Waters & Stanton PLC Scanning Accessories

Waters & Stanton PLC

Product Menu

Scanning Accessories

Online Shop > Scanners > Scanning Accessories


	ANGLER Watson Portable HF/VHF/UHF Antenna BNC * Portable HF/VHF/UHF Antenna * 100kHz - 1300MHz * Imp. 50 Ohms * BNC * Size 14.9m * Weight 175g The Angler is designed for fixed or portable use. Price: £19.95 / € (£16.98 / € / US$ Exc VAT)
	Quantity:

	M-75 Mizuho 24-2150MHz Active Variable Pre-amp BNC Frequency range: 24-2150MHz, 108-185MHz, 225-1500MHz (3 switchable filters) * Gain -10dB to +20dB * Noise figure 2dB * 50 Ohms BNC * 9V battery (not supplied) * 12V external (not supplied) Size 80 x 59 x 30mm * Weight 103g Price: £79.95 / € (£68.04 / € / US$ Exc VAT)
	Quantity:

	MFJ-15 Belt Radio Holder Price: £14.95 / € (£12.72 / € / US$ Exc VAT)
	Quantity:

	MFJ-18 Chest Harness for Handheld/Scanner Price: £29.95 / € (£25.49 / € / US$ Exc VAT)
	Quantity:

	MFJ-310 Clip Mount for BNC Antenna for edge of car window Clip Mount for BNC Antenna for edge of car window Price: £19.95 / € (£16.98 / € / US$ Exc VAT)
	Quantity:

	MFJ-310S Clip Mount for SMA Antenna for edge of car window Clip Mount for SMA Antenna for edge of car window Price: £19.95 / € (£16.98 / € / US$ Exc VAT)
	Quantity:

	MFJ-312 Clip Mount for BNC Antenna for hats Clip Mount for BNC Antenna for hats Price: £11.95 / € (£10.17 / € / US$ Exc VAT)
	Quantity:

	MFJ-315 Clip Mount holder for any handheld scanner/transceiver/GPS/phone Clip Mount holder for any handheld scanner/transceiver/GPS/phone Price: £14.95 / € (£12.72 / € / US$ Exc VAT)
	Quantity:

	MFJ-1811 Scanner/receiver Telescopic Antenna Price: £16.95 / € (£14.43 / € / US$ Exc VAT)
	Quantity:

	MFJ-1818 38in 2m "Long John" HT Price: £24.95 / € (£21.23 / € / US$ Exc VAT)
	Quantity:

	QS-200 Watson - Mobile Mount Air Vent Fitting Here's a mount that enables you to attach any handheld radio or scanner to your car ventilation grille. Clips easily onto the louvres and hand- held is attached by its belt clip. Price: £4.95 / € (£4.21 / € / US$ Exc VAT)
	Quantity:

	QS-300 Watson Adjustable Desk Stand Mount Ideal for using any handheld or scanner as a base station. Measures approx. 150 x 110 x 260mm and comes with BNC lead to attach to handheld and SO-239 socket for external aerial. The tilt and rotation angle are fully adjustable. Price: £13.95 / € (£11.87 / € / US$ Exc VAT)
	Quantity:

	QS-400 Watson Adjustable Mobile Mount This mount clips on to the dash grille and the sprung fingers and bottom support hold any size of handheld firmly in place. What is more, the handheld can immediately be removed as when necessary. The angle of this mount is adjustable. Price: £9.95 / € (£8.47 / € / US$ Exc VAT)
	Quantity:

	QS-900L Watson Suction Mount long arm for Handheld Radio, Phone or PDA Suction mount for handheld radio, phone or PDA to car windscreen, 33cm long arm Price: £14.95 / € (£12.72 / € / US$ Exc VAT)
	Quantity:

	QS-900S Watson Suction Mount short arm for Handheld Radio, Phone or PDA Suction mount for handheld radio, phone or PDA to car windscreen, 24cm short arm Price: £12.95 / € (£11.02 / € / US$ Exc VAT)
	Quantity:

	TG-SP On-glass Scanner Antenna & Cable Kit 30-1200MHz * 30-1200MHz * On-glass * 559mm colinear whip * 5m cable * Screw-on whip. Easy to fit, no holes needed. Price: £19.95 / € (£16.98 / € / US$ Exc VAT)
	Quantity:

	TG-MKD Kit for re-mounting TG On-Glass Antenna Price: £5.95 / € (£5.06 / € / US$ Exc VAT)
	Quantity:

	WAF-125 Watson Tunable Notch Filter 85-175MHz Tunable Notch Filter 85-175MHz * Neglible loss * 50 Ohms * 50cm BNC patch lead included * Size 115 x 85 x 45mm * Weight 160g Price: £31.95 / € (£27.19 / € / US$ Exc VAT)
	Quantity:

	WAM-599 Antenna Combiner 1x HF & 1x VHF/UHF Antennas into 1x BNC for scanner Price: £29.95 / € (£25.49 / € / US$ Exc VAT)
	Quantity:

	WHB-1 Watson Belt Clip Quick Release Non Slip Belt clip quick release non slip. Price: £6.95 / € (£5.91 / € / US$ Exc VAT)
	Quantity:

	WPR-2 Passive Short Wave Pre-selector for Scanners * Frequency 500kHz - 30MHz * 6 band positions * 50 Ohm to Rx * Connectors 2 x SO-239 * Size 84 x 55 x 60mm * Weight 245g approx The WPR-2 Preselector has been specifically designed for use with scanners. Essentially scanners are wide-band receivers, their front ends are not tuned as are communication receivers, and so they are susceptible to strong signal interference. THe WPR-2 provides a sharp tuning 'peak' at the frequency of operation thereby rejecting interfering signals. Price: £39.95 / € (£34.00 / € / US$ Exc VAT)
	Quantity:

	WRP-125 Watson Pre-amp 118-137MHz for Airband Receivers * 118-137MHz * Gain 15dB * Requires PP3 batt. or ext 12V @ 15mA * 50 Ohms BNC * Includes 50cm patch lead * Size 95 x 50 x 33mm * Weight 180g This is a high performance receiver preamplifier designed for the VHF aircraft band. It is inserted between antenna coax cable down lead and the receiver. It will provide a useful increase in signal strength and help pull in those very weak distant signals. It also fulfils the additional role of rejecting out of band signals. Price: £32.95 / € (£28.04 / € / US$ Exc VAT)
	Quantity:

	WRP-1300 Watson Pre-amp 25-1300MHz for Wideband Scanners * 25-1300MHz * Gain 13dB * Requires PP3 batt or ext 12V @ 15mA * 50 Ohms BNC * Includes 50cm patch lead * Size 95 x 50 x 33mm * Weight 180g This wideband receiver pre-amplifier is ideal for all scanning receivers. It is designed to be inserted between antenna and receiver and will help pull in those weak distant signals. Price: £39.95 / € (£34.00 / € / US$ Exc VAT)
	Quantity:

	WRP-2500 Watson Pre-amp 25-2000MHz for Wideband Scanners 6-20dB gain * 25 - 2000MHz * Gain 6 - 20dB * Requires PP3 batt. or ext 12V @ 10-15mA * 50 Ohms BNC * Size 95 x 50 x 33mm * Weight 180g c/w BNC - BNC patchlead This is a high performance preamplifier designed for wideband scanners. It is inserted between antenna coax cable down lead and the scanner. It will provide a useful increase in signal strength and help pull in those very weak distant signals. It also fulfils the additional role of rejecting out of band signals. Price: £29.95 / € (£25.49 / € / US$ Exc VAT)
	Quantity:

	WSC-1 Watson Body Holster Easily attaches to belt or can be worn as a body holster using the quick release harness. The holster is made of a rugged ‘camera bag’ style material with velcro secured top retaining straps. An elasticated gusset ensures that the case will self-adjust to virtually any size of scanner. Price: £19.95 / € (£16.98 / € / US$ Exc VAT)
	Quantity:

	WSC-2 Watson Hip Case The convenient and safe way to take your handheld or portable phone around with you. This case has self adjusting sides to accommodate a wide range of units. Minimum width is approx 50mm, expanding to at least 90mm. Depth to front lip is 120mm. The case incorporates both a strong fabric covered sprung trouser clip and a 65mm wide belt loop. The handheld can be kep in place by the open style top velcro fastener. Price: £12.95 / € (£11.02 / € / US$ Exc VAT)
	Quantity:

	WSC-3 Watson Hip Case Small This case is designed for the new range of miniature handhelds such as the FT-51R and the Icom IC-Q7E. The case incorporates both a strong fabric covered sprung trouser clip and a 65mm wide belt loop. The handheld can be kep in place by the open style top velcro fastener. Price: £12.95 / € (£11.02 / € / US$ Exc VAT)
	Quantity: