The iPlus controller allows routing of your external Rack or W2IHY audio to 3 radios. No more plugging and unplugging cables to send your rack audio to more than one radio. Once you connect your cables from the iPlus to your existing radios (up to 3) and connect the PTT, amplifier and speaker cables, you’re done. Imagine simply turning a switch to send your rack audio to one of three radios, and at the same time having the PTT, amplifier and speaker connections all ready to go. Connect it all up once and then forget it. The iPlus has extensive RFI and ground loop protection built in for a clean, no hum experience. The iPlus is built with a rugged steel chassis and very easy to use front-panel controls with clearly marked rear-panel connections. The iPlus and all cables are compatible with your existing EQplus, 8 or Dual Band Equalizer and iBox. The iPlus has very versatile audio inputs; Choose between Balanced XLR, Balanced ¼ TRS, Unbalanced ¼ TS, or 5-Pin DIN for a direct connection from your existing W2IHY products.
Features
• Separate level controls for each radio.
• RCA linear keying inputs from 3 radios. Select your radio, and your amplifier is connected and ready for that radio
• RCA stereo audio inputs allows you to use 1 stereo or mono speaker system for all of your radio’s receiver audio.
• Combination XLR / ¼” TRS audio input or 5-pin DIN audio input.
• Audio Phase Reversal for proper AM audio asymmetry. A must for maximum AM modulation and quality.
• Front Panel Radio Select Switch
• Invert Phase Switch
• Output Level Controls
• Audio Input Connectors (Line Level and Isolated)
• PTT Input (RCA)
• Three Audio Output Ports (5-pin DIN)
• Speaker audio switched from 3 radios to a single speaker system
• Linear amplifier keying controlled from 3 radios with a single connection to the linear amplifier
• The iPlus has extensive RFI and ground loop protection built in for a clean, no hum experience.
• Dimensions: 22.9cm W x 7.6cm H x 14cm D (Including Feet and RCA’s)
